Need to securely connect three pipes of the same size? If you're using the JG Speedfit push-fit system, you'll need this equal tee connector - it can be used with plastic or copper pipes, and is a far faster way of connecting than using traditional methods.
Installation is simple - you just push the push-fit fitting fully onto the pipe and twist the plastic nut clockwise to lock in place. No tools are needed, which makes it far easier to manoeuvre in tight spaces or to readjust joins. Tool-free dismounting is equally straightforward, by unlocking the nut and pushing the collet towards the body of the fitting. Then, you just need to pull the pipe to release it.
• Install or demount in seconds, without the need for tools
• Suitable for hot and cold water services
• Can be used on central heating systems and combi systems
• Minimum operating temperature of 20°C
• Maximum operating temperature of 105°C
• 12 bar maximum operating pressure at minimum temperature
• 3 bar maximum operating pressure at maximum temperature
• 50-year manufacturer's guarantee (T&Cs apply)
• Manufactured to BS EN 7291 Parts 1, 2, 3 and S
• WRAS-approved
• Compatible with Speedfit PEX and polybutylene plastic pipe (inserts required) and copper pipe
