Single on/off and temperature control lever. Maintenance-free non-scaling Vortex spray outlet. Swivel 200mm stainless steel spray arm. Fully temperature stabilised with overheat user protection and neon 'heat on' indicator.

Hygienic infra-red non-touch sensor activation to avoid cross-contamination. Maintenance-free non-scaling Vortex spray outlet. Swivel 200mm stainless steel spray arm. Fully temperature stabilised with overheat user protection and timed shut-off (approx 20 seconds).

Provides up to 7 litres stored hot water at point of use. Negligible standing heat loss. Adjustable thermostat 15°C - 75°C with frost protection setting. 300mm swivel spout. Install oversink, or undersink using the special monoblock chrome-mixer accessory.

Delivers hot water to up to four existing tap or mixer outlets with balanced supply of hot and cold. Minimal heat loss and energy saving from short pipe runs and insulation.Adjustable thermostat to 70°C with overheat safety cut-out, neon 'heat on' indicator and temperature pressure relief valve. Compact shape for undersink mounting.

Plumbs directly into cold water mains, providing instant hot water at point of use, to one or two existing tap or mixer outlets (especially suitable via spray tap). Flexible mounting. No standing heat losses. Two heat settings with neon 'power on' indicator.

Cold water pack is used with water supply pressure above 6 bar or where the cold water supply pipe is not long enough to accommodate expansion of hot water.

Approved to the BSEN which does not require the fitting of a temperature & pressure relief valve. This valve can still be fitted to provide added benefit of safety.