Departments

Waterproof fibreglass mesh bonded with 180 grit silicone carbide grit on both sides. Can be used wet or dry. Suitable for deburring copper & metal pipe and cleaning inside fittings.

Multi purpose key to suit ½" & 3/4" square stop cock valves and crutch head valves. Pointed handle for opening stop cock covers.

Removes stiff tap backnuts from ½" and 3/4" BSP taps.
Uses mechanical advantage of the thread of the tap tail to remove stiff nuts.
Enables rapid tap installation.
Use with tommy bar (not supplied) or cordless drill on lowest torque. Supplied with Stickfast sticky washers and full instructions.

Use for blocking off drain pipes. Fitted with removable top caps and rubber rings.

Durable quality with peripheral ribs. Fitted with Schrader valve.

Use to tighten and loosen 15mm and 22mm compression fitting nuts.

Zinc plated steel spanner with comfortable, slightly offset handle.
For 3/8" & 10mm square section radiator vent plugs & bleed screws

Made from tough plastic. Marked in millibars, the scale adjusts to zero the water level. Cover slides off and may be clipped over the base for standing the tool vertically during use. Tab enables hanging from suitable protrusion. Supplied with standard black tube.

Zinc plated hexagon steel spanner with comfortable, slightly offset handle.

For joining two pieces of copper pipe of same diameter without using fittings. Resulting capillary joint can be soft or hard soldered. Loose socket former allows easier withdrawal of tool after use. Pipe wall thickness: 0.7mm (15mm) and 0.9mm (22mm).

Carbo-nitrided carbon steel cutting blades. Not suitable for removing stainless steel olives. 22mm will not fit 3/4" Imperial olives.

Cuts copper, brass, aluminium and light gauge steel.

Copper pipe cutter. Not suitable for stainless steel.

Steel handle with hexagonal end and removable tommy bar. Fits 15mm and 22mm (½" and 3/4") nuts.

Tough plastic central mandrel has inflatable replaceable collar secured by 2 clips. Central nipple for connection to U Gauge. Reverse end of plug has removable stopper for an air test. Replace stopper and use as a drain plug for blanking off pipes. Equipped with Schrader valve inflation hose. Maximum inflation pressure 12psi / 0.86 bar.

For use with all Monument air bags fitted with a Schrader Valve. Pump includes flexible adaptor.